Singapore Mobile Proxy review for multi-account ops in 2026

If you run accounts on platforms that care about where you physically are, Singapore is a tricky market to serve from outside. The country’s telcos, Singtel, StarHub, and M1, assign mobile IPs that are well-recognised by ad platforms and e-commerce sites alike. Faking a Singapore mobile presence with a datacenter or even a standard residential IP tends to fail fast: the ASN gives you away immediately. Singapore Mobile Proxy (singaporemobileproxy.com) was built specifically to close that gap, offering 4G and 5G IPs from real Singapore carrier infrastructure.

I’ve been running multi-account setups across Southeast Asian marketplaces and social platforms for a few years now, and Singapore is a constant in that workflow. I tested Singapore Mobile Proxy over several weeks across Shopee seller accounts, Meta ad accounts targeting SG audiences, and a handful of airdrop farming wallets that require Singapore KYC-adjacent sessions. The headline verdict: it works for what it claims to do, but there are real trade-offs you should know before you commit bandwidth budget to it.

This is not a vendor-funded puff piece. The affiliate disclosure is at the bottom. Everything in here is based on actual use.

what Singapore Mobile Proxy actually does

Singapore Mobile Proxy provides mobile proxy endpoints that route your traffic through 4G and 5G modems physically located in Singapore and connected to local carrier networks. The underlying mechanism is the same as any legitimate mobile proxy: a device on a real SIM card acts as a gateway, so the IP your request arrives from is an IP the carrier assigned to that SIM. From a target platform’s perspective, your traffic looks like someone browsing from a Singapore phone.

The service offers both rotating and sticky session modes. Rotating mode cycles the IP on each request or on a set interval (1 minute, 5 minutes, 10 minutes, or on demand via an API endpoint). Sticky mode holds the same IP for a configurable duration, which matters when a platform checks session continuity, like when you‘re mid-checkout or verifying an account. You connect via HTTP/HTTPS or SOCKS5, and each port corresponds to a separate proxy endpoint.

Authentication is username/password or IP whitelisting. The dashboard is minimal but functional: you can see which ports are active, trigger manual IP rotation, and pull basic usage stats. There’s no fancy analytics layer, which is either fine or annoying depending on how you operate. I’d prefer more granular connection logs, but for most use cases the basics are enough.

One thing worth understanding: mobile IPs from Singapore carriers are dynamically assigned by the carrier, not by the proxy provider. The provider controls when the modem reconnects to get a new IP, but the IP pool itself is whatever Singtel or StarHub is allocating at that moment. This is important because it means the pool size fluctuates and is ultimately constrained by how many modems the operator runs, not an imaginary database of millions of IPs.

pricing

As of May 2026, Singapore Mobile Proxy’s pricing is structured around bandwidth (GB) rather than the per-port or per-device model some competitors use. Plans available at their site start at approximately SGD 60 for 10 GB on a monthly basis, scaling to around SGD 450 for 100 GB. Enterprise plans with higher concurrency and dedicated ports are negotiated directly.

To put that in perspective: you’re paying roughly SGD 4.50 to SGD 6 per GB. That’s expensive compared to large residential networks where you can find SG residential IPs at USD 2 to USD 3 per GB. The premium reflects the mobile carrier routing and the genuine scarcity of SG mobile endpoints.

There’s no free trial. There’s a small paid test plan (5 GB for around SGD 35) which is how I’d recommend starting before committing to a larger package. Refunds are handled case-by-case rather than guaranteed, so test first.

what works

genuine carrier ASN. every request I sent through Singapore Mobile Proxy showed up on the target platform with a Singtel or StarHub ASN. I checked this against ARIN’s whois lookup and the BGP routing data matched. Platforms that do ASN-level checks (most major ad platforms do) are not flagging these IPs as proxy or hosting traffic.

sticky sessions hold reliably. for account warming, you need sessions that don’t randomly drop or rotate mid-flow. I ran 60-minute sticky sessions across multiple ports and saw fewer than 3% session drops over two weeks of testing. that’s usable for anything that doesn’t require multi-hour persistence.

rotation API is clean. you can hit a simple endpoint to trigger an IP rotation without going through the dashboard. this matters if you’re scripting your proxy cycling in something like Playwright or a custom scraper. the API responds fast, under 500ms in my testing, and the new IP is live within a few seconds.

per-port control. each port behaves independently. you can have port A on a 10-minute rotation while port B is sticky. this lets you run different workflows through the same account without one rotation schedule bleeding into another. for multi-account work with an antidetect browser, this is the correct architecture. if you’re exploring antidetect browser pairings, antidetectreview.org/blog/ has useful side-by-side comparisons of which browsers handle per-port proxy configs cleanly.

singapore-specific targeting works. this is the core value proposition and it delivers. when I tested account-level geo-locking on a Shopee seller account (which validates location at login), the Singapore Mobile Proxy IPs passed without a flag. a datacenter IP from the same region failed within two login attempts.

what doesn’t

the IP pool is small. I saw meaningful IP repetition across ports, especially during off-peak hours when fewer modems were likely active. if you’re running more than 10 to 15 concurrent sessions, you will start recycling IPs. for platforms that track IP-to-account ratios, this is a risk. GSMA’s mobile network guidelines outline how carriers manage IP allocation, and the short version is that small modem farms cannot approximate the breadth of a national carrier’s pool.

pricing per GB is hard to justify for high-volume work. if you’re scraping or running high-request workflows, the cost scales badly. 100 GB is SGD 450 per month. for the same budget on a large residential network, you can get significantly more bandwidth with SG residential IPs. the mobile premium only makes sense when the mobile ASN is specifically required.

support response time is inconsistent. I submitted two support tickets during my test period. one was answered in under two hours. the other took just over 48 hours with no interim acknowledgement. for a service this specialised, slow support is particularly painful because there aren’t easy workarounds when something breaks.

no dedicated datacenter or ISP tier. Singapore Mobile Proxy is mobile-only. if your workflow occasionally needs static IPs or ISP-grade residential IPs for different tasks, you’re managing a second provider. some operators would prefer a single vendor.

concurrent connection limits on base plans. the starter and mid-tier plans cap concurrent connections at 5 and 10 respectively. if you’re running a larger antidetect browser setup, you hit that ceiling quickly and are forced into the enterprise tier negotiation.

who should buy

Singapore-specific account operators. if you manage seller accounts, ad accounts, or social profiles that are verified to Singapore and must consistently appear as Singapore mobile users, this service is genuinely hard to replace. the alternative is finding a larger mobile proxy network that has SG mobile coverage, and most do not have deep SG carrier pools.

airdrop farmers targeting SG-gated projects. some airdrop campaigns geo-gate their testnet phases or social tasks to Singapore participants. a Singapore mobile IP is often the difference between qualifying and not. for context on how this fits into a broader farming setup, the airdrop farming blog covers proxy strategy for geo-gated campaigns in more depth.

low-to-mid volume operators who value quality over quantity. if you’re running under 10 accounts and you need each session to look pristine, the small pool and higher price make sense. you’re not burning through bandwidth; you’re using a surgical tool.

who should skip

high-volume scrapers. if you’re pulling product data or prices at scale and SG mobile ASN isn’t a hard requirement, this is an expensive way to do it. look at residential networks with SG coverage instead.

operators who need global coverage. Singapore Mobile Proxy is Singapore-only. if your accounts span SG, MY, ID, and TH, you need a multi-geo provider regardless.

anyone on a tight bandwidth budget. at SGD 4.50 to SGD 6 per GB, you will hit financial limits before you hit technical limits on most workflows.

alternatives to consider

cloudf.one offers mobile and residential proxy coverage across Southeast Asia including Singapore, with larger pools and more geographic flexibility. worth considering if you need SG as one of several geos rather than the only one.

Bright Data mobile proxies. their SG mobile coverage is larger in raw IP count, and their pricing is comparable per GB for mobile tier. the trade-off is a more complex dashboard and a higher minimum commitment.

Oxylabs residential (SG). if mobile ASN is not strictly required and residential IPs will pass your target platform’s checks, Oxylabs SG residential is cheaper per GB. check your platform’s ASN sensitivity before defaulting to mobile pricing. for more on how to evaluate this, the proxy scraping blog has a good breakdown of ASN detection patterns by platform type.

more proxy comparisons and operator-focused reviews are indexed at the multiaccountops blog. if you’re specifically trying to match proxy type to account type, the guide at /blog/mobile-proxy-vs-residential-proxy-for-multi-account-ops/ covers the decision framework in detail.

verdict

Singapore Mobile Proxy does one thing well: it puts genuine Singapore carrier IPs in your hands with reliable session control. for operators who specifically need SG mobile ASN, there are few cleaner options available today. the small pool and high per-GB cost mean it’s a tool for precision work, not volume operations, and the support inconsistency is a real gap for a service this specialised.

Written by Xavier Fok

disclosure: this article may contain affiliate links. if you buy through them we may earn a commission at no extra cost to you. verdicts are independent of payouts. last reviewed by Xavier Fok on 2026-05-19.